e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 12
*1
• Be sure to install the USB storage device to the equipment and check if the device can be used with
this code.
• Be sure to turn OFF the write protection (the function to prevent data from erasure by the accidental
recording or deleting) of the USB storage device before performing the check, otherwise this code
cannot be used.
• It may take some time (2 sec. to 10 sec.) before this check is completed depending on the USB
storage device.
Table 7.Relation between the bridge unit connecting detection switch and connection detection for the
bridge unit and drawers
Table 8. Relation between the status of the bypass paper width sensor and paper size (width).
[9]
A 4th drawer bottom sensor Bottom position Normal
B 3rd drawer bottom sensor Bottom position Normal
C 2nd drawer bottom sensor Bottom position Normal
D 1st drawer bottom sensor Bottom position Normal
E 4th drawer tray-up sensor / End fence home
position sensor
Upper limit position /
Tray initial position
Normal
F 3rd drawer/tandem LCF tray-up sensor Upper limit position Normal
G 2nd drawer tray-up sensor Upper limit position Normal
H 1st drawer tray-up sensor Upper limit position Normal
[0]
A- --
B- --
C- --
D Security enabler Connectable Not connectable
E Judgement for acceptable USB storage device
(*1)
Acceptable Not acceptable
F- --
G- --
H- --
Status Bridge unit connecting detection switch
Connection detection between bridge
unit and drawers
Connected L L
Not connected L H
Not connected H L
Not connected H H
Bypass paper width sensor
Paper width size
3210
LHHH A3/LD
HLHH A4-R/LT-R
HHLH A5-R/ST-R
H H H L Card size
LLHH B4-R/LG
HLLH B5-R
Digital
key
Button Items to check
Contents
Highlighted display
e.g.
Normal display
e.g.
To Next Page
Loading...
