Toshiba Strata CTX28 - Day;Night Mode Schedule Per Tenant Assignment

System
Day Night Service
4-24 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
113 Day/Night Mode Schedule per Tenant Assignment
Prerequisite Program: None
The Day/Night Mode daily schedule defines the times for the start of the Work Day, Non-work Day, and
Holiday for each of the modes (Day, Day2. Night) per Tenant. Each “type of day” defined in “106 Day/
Night Mode “Type of Day” Mapping Table Assignment” on page 4-23 requires an assigned schedule.
Complete “Day/Night Mode Record Sheet” on page D-8.
Note The start time for Day 1 mode equals the end time for Night mode.
FIELD DESCRIPTION
Tenant Number Select the Tenant number for which the daily schedules will be configured. (This
feature is available with CTX R2.2 or higher and CTX WinAdmin R2.2G.0 and
higher.).
Possible values:1~8.
Work Day Enter the Day1, Day2 and Night Mode start time for Work Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note 9999 deletes or skip modes.
• 01 Day 1 Mode
• 02 Day2 Mode
• 03 Night Mode
Non-Work Day Enter the Day1, Day2 and Night Mode start times for Non-Work Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note Enter 9999 deletes or skip modes.
• 04 Day 1 Mode
• 05 Day2 Mode
• 06 Night Mode
Holiday Enter the Day1, Day2 and Night Mode start times for Holiday Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note 9999 deletes or skip modes.
• 07 Day 1 Mode
• 08 Day2 Mode
• 09 Night Mode