Toshiba Strata CTX28 - Network DSS Notify Data Delete

Services
219 Network DSS Notify Data Delete
9-60 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
Example
Refer to the illustration below and this example: When programming the DNs for telephones in Node
10, enter the DNs and their node ID numbers for DNs in nodes 11 and 12 into the Network DN table,
Program 661.
Notes
• If the same DN exists in more than one Node (i.e., DN 400), it should not be placed in the Node ID tables
of any node. The user must dial the Node ID where the DN is located, plus the DN to call the DN.
• When using Network DN tables for CTX networking, assign the Primary Node ID in Program 656, but
do not assign overlap codes.
The networking tables shows the DN numbers and node ID that have been assigned in this table.
219 Network DSS Notify Data Delete
System Availability: Not available with CTX28
This program lets you disable the DSS function for the node ID entered in this screen.
Important! Don’t use this program unless requested by Toshiba Technical Support.
1. Click Services > Networking > Network DSS Notify Data Delete.
2. Enter the Node ID of the Network DSS key Notify Data to be deleted.
Node 11
6995
202200
400301
300400
Node 10
201
400
QSIG/Non-QSIG
QSIG/Non-QSIG
QSIG/Non-QSIG
302
Node 12
DN Node
202 11
300 11
201 12
302 12
Node 10
Network DN
Table (Prog. 661)
DN Node
200 10
202 11
300 11
Node 12
Network DN
Table (Prog. 661)
DN Node
200 10
301 10
201 12
302 12
Node 11
Network DN
Table (Prog. 661)
6959