System Error Codes
Station Programming Error Codes
Strata CTX Programming - Part 4: Appendices 6/04 B-5
System Error Codes
Station Programming Error Codes
Program Code FB
Sub-
parameter
Error Descriptions
200
33
)%
The entered Shelf/Slot/Circuit value is out of range.
33
)%
The entered System Call Forward index is out of the range.
49
)%
The selected PDN(s) conflicts with an existing PDN(s)
assignments for the selected circuit.
49
)%
Station Type cannot be changed.
49
)%
)%
The desired DN does not exist.
51
)%
The entered value conflicts with an existing numbering
scheme.
52
)%
The entered value conflicts with an existing ISDN assignment
etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The DN does not exist.
80
)%
A PCB without “DKT/SLT setting allowed” is designated for a
PCB connecting the selected ISDN extensions.
96
)%
The allowed number of extensions has been exceeded.
98
)%
The quantity of station speed dial bins entered exceeds the
system's capacity.
201
50
The DN entered is the DN that is used as the administration
terminal.
FB which this error occur : FB01
51
)%
The entered number is not the extension number.
52
)%
The entered number is not the extension number.
80
)%
The entered value is not a valid extension.
202
33
)%
The equipment number entered is out of the range.
49
)%
PCB assignment is not set for the ISDN card connecting
selected extensions.
49
)%
The entered equipment is using as other ISDN extension.
49
)%
An ISDN trunk channel group conflict has been detected.
49
)%
Although the P-P connection was selected, an additional DN
is registered.
49
)%a)%
The desired value conflicts with existing ISDN extensions.
51 -
The Primary DN entered conflicts with a value of an existing
numbering scheme.
51
)%)%
a)%
The desired value conflicts with existing number schemes.
52
)%
A DN used for DKT extensions is designated.
To Next Page
Loading...
