Toshiba Strata CTX28 - Page 468

System Error Codes
Station Programming Error Codes
B-6 Strata CTX Programming - Part 4: Appendices 6/04
202
52
)%a)%
The additional ISDN extension number cannot be registered.
The number is already in use by a DKT extensions, etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)% The DN entered is invalid.
80
)%
A PCB without ISDN extension settings allowed’ is designated
for the PCB connecting the ISDN extension(s) selected.
96
)%
The number of channel group exceeds the system capacity
when ISDN station is registered.
96
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
98
)%
The quantity of station speed dial bins entered exceeds the
system’s capacity.
203
33
)% The new DN is not assigned.
49
)%
The new DN value conflicts with an existing value DN, PhDN,
etc.
51 -
The Primary DN entered conflicts with a value of an existing
numbering scheme.
51
)%
The new DN value conflicts with an existing numbering
scheme value.
52
)% The new DN value conflicts with existing group extensions.
80
)% The new DN value does not exist.
204
33
)% The Call History memory size entered is wrong.
49
)%
The number of attendant consoles exceed the number
specified in the system.
52
)% DKT is not assigned to DN (ISDN, etc.).
80
)% The DN entered is an extension number that does not exist.
98
)% Allowable Feature Button number is exceeded.
98
)% Allowable Call History Memory size is exceeded.
205
33
)%
100
110
120
130
140
Sub-parameters must be assigned.
33
120 The line number entered is out of range for the system’s
capacity.
33 130 The GCO key group/index entered is out of the range.
33 140 The POOL group entered is out of the range.
33 530 The BGM number entered is out of the range.
Program Code FB
Sub-
parameter
Error Descriptions