Trunks
315 T1 Trunk Card
6-20 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
319 Intercept Treatment
Prerequisite Program: None
This command assigns Intercept positions for Strata CTX Day/Night schedules. Intercept positions are
used when the destination of a trunk line call is not determined with DID or DIT.
315 T1 Trunk Card
System Availability: Not available with CTX28
Prerequisite Program:
100 page 4-1
This command assigns T1 Trunk Card Data to the system.
1. Complete the “Trunk Timer/DIT
Record Sheet” on page D-27.
2. From the Program Menu, click
Trunk > T1. The T1 Trunk Card
Data Assignment screen displays
(shown right).
3. Enter T1 card location in Shelf/Slot
field (xxyy). The selected slot
requires a DTU Card.
• xx = Cabinet 01~07
• yy = Slot 01~10
...or click the following buttons:
•List – to view a summary list of programmed Trunks.
• Copy – to T1 trunk equipment.
4. Enter values for Program 315.
5. Click Submit.
FIELD DESCRIPTION
Tenant Number Select the Tenant number for which the Intercept Destinations should be
assigned.
Possible values: 1~8.
01 Day1 Destination Type
02 Day2 Destination Type
03 Night Destination Type
Select Destination Type for each.
Possible values: None (default), Dialing Digits or Night Bell
Day1 Destination
Day2 Destination
Night Destination
Enter Destination for each.
Possible values: Up to 32 ASCII characters (default = no value)
• To intercept with a DN use 0~99999
• To intercept with a Network DN use 1~32
• To intercept with Dial Digits Paging 1~16
To Next Page
Loading...
