System Error Codes
Trunk Programming Error Codes
Strata CTX Programming - Part 4: Appendices 6/04 B-13
System Error Codes
Trunk Programming Error Codes
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions
300
33
)%
The equipment number entered is out of the range.
33
)%
The ILG entered is out of the range.
33
)%
The OLG entered is out of the range.
33
)%
The hunting order entered is out of the range.
49
)%
When modifying previously assigned equipment:
• The designated PCB Type does not allow CO trunk
assignments.
• The designated circuit does not allow CO trunk
assignments.
49
)%
The ISDN ILG number is designated for analog trunks or the
entered ILG number does not exist in the system.
49
)%
“0” was entered in ILG when OLG was not registered.
49
)%
The OLG entered is not registered in the system.
49
)%
The ISDN OLG number is designated for analog trunks or the
entered OLG number does not exist in the system.
49
)%
“0” was entered in OLG when ILG was not registered.
49
)%
)%
A conflict exists between the ILG number and the OLG
number trunk type.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
A trunk number that does not exist in the system has been
selected.
80
)%
The entered ILG number does not exist in the system.
80
)%
The entered OLG number does not exist in the system.
96
)%
Allowable number of trunks has been exceeded.
96
)%
The line number entered exceeds the system's capacity.
301
33
)%
The trunk number entered is out of the range.
80
A trunk number that does not exist in the system has been
selected.
To Next Page
Loading...
