Services
Destination Restriction
9-36 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
570 Account Code Digit Length
Prerequisite Program: None.
Accounting Codes need to be specified for the number of digits that are expected to be used for registering
a number. This allows dialing within Strata CTX to proceed automatically once the correct account code is
dialed. The following numbers are then dialed digits used for making the phone call.
A second length is provided to allow the number of digits to be used for verification of the code to be less
than the total code entered; thus, the code may contain two parts, one required and one part optional to the
user.
506 Verified Account Codes
Prerequisite Program: 570 page 9-36
This program adds or deletes entries in the DR Table associated with the DRL entered in Step 3 on 9-33..
FIELD DESCRIPTION
01 Verified Digit Length The Verified Digit Length sets a number of digits to verify with a pre-set list.
This number may be the same or smaller than the account code digits set to be
entered for creating a complete accounting code.
Note This field is not changed, when “506 Verified Account Codes” on
page 9-36 are registered.
Possible values: 4~15 (default = 4)
02 Registered Digit Length The Registered Digit Length sets a number for the digits to be entered to make
a complete accounting code entry.
Note The Registered Digit Length (
)%
) must be greater than or equal to
the Verified Digit Length (
)%
).
Possible values: 4~15 (default = 6)
FIELD DESCRIPTION
Account Code Enter a valid accounting code that the user will be expected to dial. Digits 0~9
can be used.
Note The Account Code is set to the same digit length as the Verified Digit
Length in Program 570 above.
Possible values: Up to 15 ASCII characters (default = no value)
01 Verified Flag The Account Code Flag determines whether the number entered is to be used
as a verified account code or not. Some applications may allow users to dial an
accounting code which changes the restriction level for the call allowing it to be
placed.
Possible values: Set or No Set (default)
Note To delete a Verified Account Code set this field to No
Set.
02 DRL The DRL assigned to an accounting code allows users to override their
stations assigned DRL enabling a call to be placed.
Possible values: 0~16 (default = 0)
03 FRL The FRL assigned to an accounting code enables users to override the station
assigned FRL.
Possible values: 0~16 (default = 0)
04 Network COS Assign the Network COS to be used by this accounting code.
Possible values: 1~32 (default = 1)
To Next Page
Loading...
