Toshiba Strata CTX28 - System Programming Error Codes

System Error Codes
System Programming Error Codes
B-2 Strata CTX Programming - Part 4: Appendices 6/04
System Programming Error Codes
Program Code FB
Sub-
parameter
Error Descriptions
100
33
)% The entered Cabinet/Slot value is out of range.
33
)% The entered PCB Type is out of range.
33
)%
In CTX100, the Card Type Code other than ASTU (STU) was
assigned into S109.
33
)%
In CTX670, the equipment entered is S109 or S110.
In CTX100, the equipment entered is S110.
49
)%
Deleting a Card (000) – Programmed station and/or trunk
data must be deleted before a card can be deleted.
49
)%
Changing Card Type Code – Card Type cannot be changed.
Delete the existing Card Type before entering a new Card
Type.
49
)% The designated BIOU is already in use.
49
)%
IOU card cannot be deleted because the Control Relay is
assigned to that card.
49
)%
The PCB cannot be assigned to the designated equipment
position.
49
)% “004” is not assigned as Card Type Code.
50
)%
One of the required parameters (PCM Highway, BDKU Type
or TEI Assignment) has not been assigned.
50
)%
The PCM highway value entered is not applicable for the
desired PCB assignment. PCB parameters are required for
PDKU or BDKU, RDTU, RDSU, RPTU.
50
)%
The Channel Type value entered is not applicable for the
desired PCB assignment. PCB parameters are required for
PDKU or BDKU, RDTU, RDSU, RPTU.
50
)%
The TEI Type value entered is not applicable for the desired
PCB assignment. PCB parameters are required for PDKU or
BDKU, RDTU, RDSU, RPTU.
54
)% The number of MF2U cards exceeds the system limit.
102
33
)% The entered Feature Code is out of range.
33
)% The OLG entered is out of range.
49
)%
An invalid OLG number was entered in OLG Number field
when assigning a Flexible Numbering Feature code of 551.
50
)% “0” is not a valid OLG Number.
51
)%
Flexible Numbering Plan values cannot be repeated. The
value entered cannot be registered (e.g., If 1234 is registered,
123 cannot be registered).
52
)%
The value entered conflicts with an existing extension and
cannot be registered.
103 -
 See “Common Error Code Table” on page B-1.