Telephone Button Programming
900 Series Programs
13-108 Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Program Update
This program enables you to update the Strata CTX programs.
Program Number(s): 911
Prerequisite Program:
Format SmartMedia Card
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG
4
4
4
4
4
.
At the PASSWORD= prompt, Enter your password and press
+ROG
.
At the PROG= prompt enter
and press
+ROG
.
Note Before running this program, make sure the SmartMedia card is properly formatted. See “Format/
Unmount SmartMedia” on page 13-105 for more details.
1. Press
)%
to enter your Backup choice. Press the
6FUROO
or
3DJH
button to view your selection
options.
2. Press
.
)%
and
)%
should blink green.
3. Press
+ROG
to execute. Press
+ROG
again to Cancel. This program stops running if you exit
programming mode from your telephone.
FB Name FB Summary Value LCD Prompt
Update Function
01 Enter 1 or 2 to identify the type of Update
intended.
Select 3 to cancel a running update.
1:Update
2:Reboot
3:Cancel
1:Update
2:Reboot
3:Cancel
Total B lo c ks
02 View total blocks to be updated (total blocks
will vary depending on software versions).
0~65536 (CTX670)
0~128 (CTX100)
default = 0
n/a
Copied Blocks
03 View number of blocks copied. 0~65536 (CTX670)
0~128 (CTX100)
default = 0
n/a
Active Side Status
04 Backup Type Display 1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
Stand by Side Status
05 Stand by Backup Type 1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
1:Normal
2:Trial
3:Fault
4:Don’t Care
5:Error
Active Side Number
06 Active Side Number. 0 or 1
default = 0
ACT SIDE=
Status
07 View Backup Status. 1:Idle
2:Running
3:Success
4:Error
1:Idle
2:Running
3:Success
4:Error