IP Telephone Programming
250 IPT Data Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 8-7
IP Telephone
Programming
250 IPT Data Assignment
Program 250 is used to set up the IP address of the specific IP phone card to support IP-Telephone feature.
The IP Phone Prime DN must be assigned using Program 200 before you configure the BIPU card.
1. From the Program Menu, click
IP-Telephone > Station IP Data.
The Station IP Data
Assignment screen displays
(shown right)
2. Enter Program 250 data.
3. Click Submit.
FIELD DESCRIPTION
Prime DN Enter the IPT Prime Directory Number (PDN)
Possible values: Up to five digits.
01 Station ID Station ID is set from the IPT to match its PDN in station Program ’369 Hold-2-
FB05’. The station ID is the same as the station PDN unless there is more than one
CTX system having BIPU-Ms on the same network. In this case the station ID for
each IP telephone must contain the CTX Node ID+PDN.
Possible values: Up to five digits.
02 Station IP Address
Type
Select the Station IP Address to be static ’fixed’ or dynamic in which case it obtains
an IP address from a DHCP server.
Possible values: Fix or Any (default)
03 Station IP Address Enter the Station static IP Address if a static address is needed per Station IP
Address Type set in 02 above.
04 Automatic assignment
of Station ID
Use Automatic when the IPT has no Station ID. Use ’Not Automatic’ when IPT has
station ID in the IPT setting. In Program 150, FB01 is the same parameter for
system.
When ’Don’t Care’ is set, Program 150-01 precedes in Program 250-04.
Enabling Program150-01 is equal to using ’automatic’ in Program 250-04.
Disabling in Program150-01 is equal to ’not automatic’ in Program 250-04. When
IPT requests to connect to a Strata CTX with no station ID, CTX searches for a
PDN that is set in this parameter as ’automatic’, and send the PDN to the IPT, and
IPT records it in the IPT setting.
Possible values: Permitted, NotPermitted or DontCare (default)
6719
To Next Page
Loading...
