System
105 System Data
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 4-13
System
105 System Data
Prerequisite Program: None
This command assigns system settings for your Strata CTX.
1. From the Program Menu click
System > System Data. The
System Data Assignment screen
displays (shown right).
2. Enter System Parameter data
using the table below.
3. Click Submit.
23 System Timer Network
DSS Refresh Timer
Select Network DSS Refresh Timer (20 -180 seconds). The time interval when all
Network DSS settings are refreshed system wide.
Note DSS button LEDs change state immediately when the status of the DSS
button changes - regardless of this timer value.
Possible values: 20~180 seconds (default = 30)
24 Outgoing Number
Display Timer
This timer sets how long dialed numbers will display on telephone LCDs for outgoing
line calls. (This feature is available with CTX R2.2 or higher and CTX WinAdmin
R2.2G.0 and higher.)
Possible values:1~120 seconds (default = 10)
FIELD DESCRIPTION
01 Executive Override Enable break in warning tone for Executive Override.
Possible values: Enable (default) or Disable
02 Station MOH Select MOH for private lines and stations.
Possible values: Quiet Tone, External 1 (default), External 2, External 3, External
4, External 5, External 6, External 7, External 8, External 9,
External 10, External 11, External 12, External 13, External 14 or
External 15
03 Ring Transfer Tone Select tones for the transferred party to hear after a ringing transfer takes place.
Possible values: RBT (default) or MOH
FIELD DESCRIPTION
To Next Page
Loading...
