System
104 System Timer
4-12 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
09 Dial Input Timer Permits dialed input for a telephone and trunk using DTMF.
Possible values: 0~60 sec. (default = 20)
10 Delay 1 Ringing Timer Specifies the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 12)
11 Delay 2 Ringing Timer Selects the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 24)
12 Door Unlock Timer Select the length of time to send an electrical signal to a door for releasing the lock.
Possible values: 1~30 sec. (default = 6)
13 9+11 Judgement Timer The 9+11 Inter-digital timer provides a timing value (1~30 seconds) for the system to
wait for additional digits to be dialed looking for the 911 or 9+911 dialed codes for
treatment using the E911 procedures rather than normal dialing treatment.
Possible values: 1~30 sec. (default = 5)
14 Emergency Call Timer Sets a time for advancing the call to the next station in a list of destinations for the
call.
Possible values: 10~180 sec. (default = 30)
15 ABR Busy Detection
Time
The Destination Busy Detection timer sets the time to wait while looking for a busy
condition on an external call. If detected, it will trigger the initiation of the Automatic
Busy Redial cycle.
Possible values: 1~30 sec. (default = 5)
16 Lost Call Timer The Lost Call timer sets the time that a failed transfer recall will ring on the
originating station prior to attempting to recall a secondary location.
Possible values: 1~600 sec. (default = 180)
17 Lost Call Final Timer The Lost Call Final timer sets the time that a failed transfer recall will ring on the
secondary location before being automatically disconnected.
Possible values: 1~600 sec. (default = 30)
18 DTMF Tone Sending
Time
The DTMF tone sending duration for dialing on CO Lines.
Possible values: 80msec (default) or 160msec
19 Auto Disconnect Time after which an unsupervised trunk may be automatically released.
Possible values: 0~60 min. (default = 0)
20 Tie Line Delay Timer This timer inserts a pause before any dialled information is sent to a Tie Line, this
pause
allows the distant end time to prepare for the receipt of dialled digits.
21 Answer timer before
disconnect
If an incoming DISA call routes over a Tie Line and the call is not answered by the
distant end within a certain period of time the DISA caller will be cut off. The time
period before cut off is determined by this setting.
22 Outgoing Call Talking
Disconnect Timer
If Program 103 FB40 is set to enable then after this timer expires the out going call is
cut off
FIELD DESCRIPTION
To Next Page
Loading...
