Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-105
Telephone Button
Programming
Format/Unmount SmartMedia
This program enables Administrators to format a SmartMedia card from Strata CTX WinAdmin or the
telephone button pad.
Note Strata CTX WinAdmin cannot view SmartMedia files directly. Additional hardware is required to
view the contents of the SmartMedia card.
Program Number(s): 908
Prerequisite Program:
None
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG
4
4
4
4
4
.
At the PASSWORD= prompt, Enter your password and press
+ROG
.
At the PROG= prompt enter
and press
+ROG
.
1. Press
)%
to enter parameter. Enter
~
as your command choice. Press the
6FUROO
or
3DJH
button to
make your selection.
2. Press
+ROG
to confirm and
+ROG
again to execute.
3. Wait for the
PROG=
prompt to appear before proceeding.
4. Enter another program number to continue programming or press
+ROG
again to exit programming
mode.
Strata CTX SmartMedia Directories
Running the Normal and Forced options of this program creates five directories on the SmartMedia card as
follows:
• Admlog – The Admlog folder saves
• Errlog – System error logs are saved into this folder.
• Evnttrce – Strata CTX WinAdmin Event Trace files are saved into this folder.
• Progdata – Your Strata CTX programmed settings are all saved in this folder.
• Program – The operating software and default data of the Strata CTX is saved in this folder.
When a backup is performed, Strata CTX saves programmed data to the
Progdata folder.
FB Name FB Summary Value LCD Prompt
Control
01 Choose SmartMedia card formatting method:
Normal – creates any Strata CTX SmartMedia
directory that does not exist already. Exiting
directories are not overwritten by this procedure.
Forced – erases any existing directories and files.
All existing data is overwritten. See Strata CTX
SmartMedia Directories for more information.
Unmount – writes data into SmartMedia Card.
Always run unmount before removing the
SmartMedia card to prevent damage to the card.
Transfer – writes data from static RAM to
SmartMedia Card.
1:Normal
2:Forced
3:Unmount
4:Transfer
1:NORMAL
2:FORCED
3:UNMOUNT
4:TRANSFER
To Next Page
Loading...
