Installation
WinCTX Offline Programming CTX R2.21 MH108
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 3-25
Installation
Stopping WinCTX
1. Click the Stop button or click
the button in the right corner.
WinCTX displays window
(shown right)
.
2. Click Yes to stop WinCTX
...or click No to continue using
WinCTX.
Important! Data changes will not be stored in the default.dat file unless you backup your data using
WinAdmin.
Viewing the CTX Release Number Supported by WinCTX
To display the CTX release number supported by WinCTX, open WinCTX and click on the WinCTX icon
in the left corner, then click on the “version number WinCTXxxx.” The CTX release (R2.21) and build
(MH109 or MH110) number that WinCTX will emulate when it is running displays.
When you run WinCTX, it always shows the same CTX release and build information even if you open a
default.dat file with different release and build numbers. You can restore the “default.dat” files created by
WinCTX to CTX systems with different release numbers per the rules below.
Rules for Opening/Restoring “default.dat files”
Basically when opening and restoring default.dat files using WinCTX, the version of WinCTX must match
the version of CTX. If the version numbers do not match, data errors will ocuur after updating the CTX
using the default.dat file created or edited using WinCTX. WinCTX R2.21 MH109 or MH110 can only be
used CTX R2.21 MH109 or MH110. If MH014 is released it may be compatible with WinCTX R2.21
MH109 or MH110 – this will be specified in the MH014 release documentation.
To Next Page
Loading...
