Installation
WinCTX Offline Programming CTX R2.21 MH108
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 3-23
Installation
Basic Procedure for Using WinCTX
This is a summary of how to use WinCTX. For detailed, step-by-step instrctions, see the following section
“Run WinCTX” on page 3-23.)
1. Open and then Start WinCTX. Be sure to open the correct version (see “Rules for Opening/Restoring
“default.dat files”” on page 3-25).
2. Run WinAdmin and connect to WinCTX (select Local WinCTX 127.0.0.1)
3. Edit the database using CTX WinAdmin.
4. Backup the database using CTX WinAdmin.
5. Exit CTX WinAdmin.
6. Stop WinCTX.
Run WinCTX
1. Click on the WinCTX100 or
WinCTX670 icon (shown right).
2. If Simple Network Management Protocol (SNMP) service for Windows2000 or XP is activated,
WinCTX executes “StopSnmpAgent.exe.” “Stopping SNMP Service. Please wait...”
appears on screen. After the SNMP Service is stopped, the Main window for WinCTX670 or
WinCTX100 appears (shown in Step 3, below).
If another application is using the SNMP port, you will see the window shown below. You will have to
manually stop the application by selecting Control Panel > Administrative tools > Services. Stop
SNMP service to prevent connection problems between WinAdmin and WinCTX. After stopping
SNMP service(s), click OK to continue.
3. For WinCTX670, select
System Size (for
WinCTX100, skip to the
next step):
• Basic system (Small) –
Assumes BBMS and
BEXU is not installed)
• Expanded system
(Large)– Assumes
BBMS and BEXU is
installed)
The WinCTX670 port
ranges are:
• CTX100: 001 to 112
• CTX670 (Basic
System): 001 to 192
• CTX670 (Expanded System): 001 to 672
Win
CTX
Win
CTX
7058
Shows the
type of CTX
database
supported.
7054
To Next Page
Loading...
