Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-109
Telephone Button
Programming
Make Busy Control
When an error occurs in hardware resources used for a station or a line fails, this feature makes them busy.
The station or line PCB can be disabled temporarily to perform maintenance or parts replacements as well.
This program is only available in the telephone button programming mode.
Program Number(s): 912
Prerequisite Program:
Format SmartMedia Card
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG
4
4
4
4
4
.
At the PASSWORD= prompt, Enter your password and press
+ROG
.
At the PROG= prompt enter
and press
+ROG
.
At the CABINET= prompt enter the Shelf number.
Note The Shelf number is entered in “XX” format where Shelf is a two digit value from 01~07
corresponding to the Strata CTX Cabinet number. See “Program Button LEDs” below for a
description of the LED display.
1. Press
)%
~
)%
to enter your Make Busy selection for the appropriate Slot in the Cabinet entered in
Access Sequence above.
Note The slot to which your programming phone is connected can not be set to Make Busy.
2. Press
+ROG
to execute.
3. Press
+ROG
again to return to CABINET= prompt.
4. Press
+ROG
to return to the PROG= prompt.
5. Enter another program number to continue programming or press
+ROG
again to exit programming
mode.
Program Button LEDs
The LED blink pattern indicates the following:
• Red continuous blinking – PCB experienced a Make Busy status error.
• Red continuous illumination – PCB Make Busy Status mode is on.
• Green continuous blinking – PCB Make Busy Status mode is stand by.
• Green intermittent blinking – PCB Make Busy Status mode is idle.
FB Name FB Summary Value
Equipment 00 Enter Cabinet Number 01~07 (value=xx)
Slot #1
01
Enter
or
1: Set make busy
2: Clear make busy
Slot #2
02
Slot #3
03
Slot #4
04
Slot #5
05
Slot #6
06
Slot #7
07
Slot #8
08
Slot #9
09
Slot #10
10
To Next Page
Loading...
