Trunks
Service
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 6-19
Trunks
Service
Program Number(s): 311 and 319
These commands assign Assigns Direct Inward System Access (DISA) properties.
1. From the Program Menu, click
Trunk > Service. The Trunk
Services screen displays (shown
right).
2. Enter Program 311 data.
3. Enter Program 319 data.
4. Click Submit.
311 DISA Security Code
Prerequisite Program: None
Assigns DISA parameters.
FIELD DESCRIPTION
01 DISA Enabled Enable DISA security code.
Possible values: Enable or Disable (default)
02 DISA Code Enter DISA security code. Only required if DISA Security Code is marked as
necessary.
Possible values: Up to 15 digits (default = no value)
03 Response Timer Choose the time, in seconds, the CTX will wait before answering an incoming DISA
call.
Possible values: 0~30 (default = 5)
04 Idle Timer Choose the time, in seconds, the CTX will wait for the first DTMF tones after
answering a DISA call.
Possible values: 0~60 (default = 10)
05 Tie Line Access Enable this feature to allow DISA callers to access Tie lines when they call into the
system. (This feature is available with CTX R2.2 or higher and CTX WinAdmin
R2.2G.0 and higher.)
Possible values: Enable or Disable (default)
To Next Page
Loading...
