Services
Strata Net QSIG Over IP
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 9-61
Services
Strata Net QSIG Over IP
System Availability: Not available with CTX28
To use programs 671 and 672, refer to “Strata Net over IP Programming Guidelines” on page A-13.
671 IP Address Convert Table
1. Click Services > Networking > Network
Over IP.
2. Enter Program 671 data.
3. Click Submit.
FIELD DESCRIPTION
Remote Node ID
Enter the Node ID of the remote CTX that the primary CTX should route to in
the IP Private Network.
Possible values: Up to six digits.
01 BIPU-Q IP Address Route 1
Enter the IP Address of the remote BIPU-Q IP that should be routed to first.
Possible values: 0~255
02 BIPU-Q IP Address Route 2
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in the first BIPU-Q route is busy or disabled.
Possible values: 0~255
03 BIPU-Q IP Address Route 3
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1 and 2 are busy or disabled.
Possible values: 0~255
04 BIPU-Q IP Address Route 4
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2 and 3 are busy or disabled.
Possible values: 0~255
05 BIPU-Q IP Address Route 5
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2, 3 and 4 are busy or disabled.
Possible values: 0~255
06 BIPU-Q IP Address Route 6
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2, 3, 4 and 5 are busy or disabled.
Possible values: 0~255
To Next Page
Loading...
