Trunks
ISDN
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 6-25
Trunks
302 PRI and IP QSIG
System Availability: Not available with CTX28
Prerequisite Program:
100 page 4-1
The PRI (RPTU, BPTU) and IP QSIG (BIPU-Q) interface cards need to have a number of assignments for
defining its operation. These include assigning which channels are available for use and the location of the
D-channel or signaling channel. The D-channel exists on the circuit assigned in this command. Also, a
number of optional functional capabilities also need to be enabled or disabled.
For BIPU-Q channel groups, parameters 01~04 must be configured, all other parameters should remain at
default. All parameters should be configured for ISDN. Many of these are normally set to default.
Note PRI ILGs and OLGs are assigned using “Call-by-Call” on page 6-29. Therefore, ILG and OLG must
be set to 0.
1. Complete the “PRI Trunks
Record Sheet” on page D-29.
2. From the Program Menu, click
Trunk > ISDN > PRI.
3. Enter Channel Group number
...or click one of the following
buttons:
• List – View a summary list of
programmed Trunks.
• Create – Assign a new Trunk
with default settings.
• Copy – Enter an Channel
Group number and click
Copy to make a new Trunk
assignment with settings
copied from the Channel
Group entered.
• Delete – Delete an Trunk
(Trunks 1~128 for CTX670 and 1~32 for CTX100).
4. Enter data.
5. Click Submit.
FIELD DESCRIPTION
Channel Group Channel Group Number.
Assign the proper PAD levels to channel groups in Programs 107, 108 and 114.
These levels are critical for ISDN and IP QSIG speech levels, as well as Quality Of
Service.
Possible values: 1~32 (CTX100), 1~48 (CTX670 Basic), 1~128 (CTX670 Exp),
(default = no value)
5722
To Next Page
Loading...
