EasyManua.ls Logo

Toshiba Strata CTX28 - Page 184

Toshiba Strata CTX28
592 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Trunks
ISDN
6-24 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
15 Initialization Display Enter the text to be displayed for SPID Initialization.
Possible values: Up to 4 ASCII characters (default = User)
16 SPID #1 Enter the SPID value. These fields are required if you selected National ISDN in
Protocol. When no data is entered, any previously entered information is overwritten.
Possible values: Up to 20 ASCII characters (default = No Value)
17 SPID #2
18 T-Wait Timer Enable the T-Wait Timer. This field is needed if you selected National ISDN in Protocol
above. This timer, used along with the SPID, assigns random initializing SPID times to
prevent BRI interfaces from re-initialize at the same time after a reset or power
outage.
Possible values: Enable or Disable (default)
19 Voice Calls Select the number of simultaneous voice (speech) calls that can exist at the same
time on this interface.
Possible values: One or Two (default)
20 Trunk Subscriber 1 Enter the telephone number for subscriber 1. Telephone number should be consistent
with D channel data. If no data is entered in this field any previously programmed
information is lost.
Possible values: Up to 10 digits (default = no value)
21 Trunk Subscriber 2 Enter the telephone number for subscriber number 2. If no data is entered in this field
any previously programmed information is lost.
Possible values: Up to 10 digits (default = no value)
22 Layer 1 Short Break
Tolerant
If layer 1 is interrupted for a short period of time CTX will ignore it
23 TEI assignment TEI assignment for ISDN CO Trunk
Leave in default
Possible values: TEI FIXED, SINGLE TEI or 3:TWO TEI (default)
24 Malicious Call ID Enable - to be allow Malicious Call ID to be sent by this terminal.
Disable - to not allow Malicious Call ID to be sent on this terminal.(also see Program
302-31)
Note: MCID supplementry service must be provided by PSTN for this feature to
operate.
Possible values: Enable or Disable (default)
Table 6-1 Bearer Capability Table
Bearer Services
Bellcore
National ISDN
ETSI TTC
Circuit Mode
Speech X X X
3.1 KHz X X X
7 KHz X X
Unrestricted
Digital
Information
64 Kbps X X X
Rate adaptation
from 56 Kbps
X
2x64 Kbps X X
FIELD DESCRIPTION

Table of Contents

Other manuals for Toshiba Strata CTX28

Related product manuals