Trunks
DID/DNIS Table View
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 6-21
Trunks
DID/DNIS Table View
System Availability: Not available with CTX28
This screen provides the DID/DNIS Table View on the DID command page.
Important! To avoid any errors, you must first set the digit length under Trunk > ILG.
¥
To access DID/DNIS table
view
¥
Click Trunk > DID/DNIS
Table View...or use Program
309.
See “Table Views” on page 2-8
for table functionality.
Note You can navigate this
table using the ILG and
the DID/DNIS which are
the first and second drop-
downs between the
Previous and Next
buttons.
FIELD DESCRIPTION
T1 Equipment
Location
Enter the RDTU PCB equipment location.
Enter data as XXYYZZ:
XX=cabinet 01~07
YY=slot 01~10
ZZ=analog trunk circuit 01~08 or ZZ=T1channel 01~24.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
01 Coding Format Select the Coding Format.
Possible values: None, PZC, B8ZS (default) or ZCS
02 Frame Format Select the Frame Format.
Possible values: SF Mode or ESF Mode (default)
04 Receive PAD Select the Receive PAD values.
Possible values: None, Plus 6 dB, Plus 3 dB, Zero dB (default), Minus 3 dB, Minus
6 dB, Minus 9 dB, Minus 12 dB or Minus 15 dB
05 Send PAD Select the Send PAD values.
Possible values: None, Plus 6 dB, Plus 3 dB, Zero dB (default), Minus 3 dB, Minus
6 dB, Minus 9 dB, Minus 12 dB or Minus 15 dB
To Next Page
Loading...
