IP Telephone Programming
152 Voice Packet Configuration Table Assignment
8-6 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
02 Jitter Buffer Type The default values for the selected codec is recommended. If the voice quality is not
as expected you can change the jitter buffer type of DSP on BIPU.
Possible values: Fixed, Sequential, or Adaptive
The default values are: G.711 = Adaptive,
G.729A = Sequential (recommended).
03 Jitter Buffer Length The default values for the selected codec is recommended. If the voice quality is not
as expected you can change the jitter buffer length.
Possible values: 0~250
The default values are: G.711= 100msec., G.729A=40msec.
04 Max. Acceptable Delay Not available in Release 2.0.
05 Measurement Period Not available in Release 2.0.
06 Packet Loss Ratio Not available in Release 2.0.
07 Packet Loss Threshold If packet loss is more than 10, an error is recorded in the CTX error log and you
cannot talk by IPT. The default value 5 is recommended.
Possible values: 0~10
FIELD DESCRIPTION
To Next Page
Loading...
