Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-107
Telephone Button
Programming
Note Before running this program, make sure the SmartMedia card is properly formatted. See “Format/
Unmount SmartMedia” on page 13-105 for more details.
1. Press
)%
to enter your Backup choice. Press the
6FUROO
or
3DJH
button to view your selection
options.
2. Press
.
)%
and
)%
should blink green.
3. Press
+ROG
to execute. Press
+ROG
again to Cancel. This program stops running if you exit
programming mode from your telephone.
¥
To view Backup progress
1. While the program is running (
)%
and
)%
blink green), press
)%
to view the total number of
files to be transferred.
2. Press
)%
to view the current file number that is being transferred.
3. The Backup is complete when
)%
blinks intermittently.
4. To verify success, push
)%
. Your telephone LCD should indicate *1.ALL_OK.
5. Press
+ROG
to exit.
Note Do not press the
+ROG
button. Pressing the
+ROG
button restarts the Backup procedure.
To Restore data from the SmartMedia card to Strata CTX, see “System Initialize” on page 13-97.
Backup State 04 All_Ok – Backup completed with no errors.
Partial_Ok – Backup has completed with
errors.
NG – Backup has failed.
Cancel – Cancel Backup.
Importing – Program data is being
restored.
Exporting – Program data is being sent out.
1:normal end all
2:normal end part
3:abnormal end
4:cancel
5:importing
6:exporting
FB Name FB Summary Value LCD Prompt
To Next Page
Loading...
