EasyManua.ls Logo

Toshiba Strata CTX28 - Page 476

Toshiba Strata CTX28
592 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Error Codes
Trunk Programming Error Codes
B-14 Strata CTX Programming - Part 4: Appendices 6/04
302
33
)%
The equipment number entered is out of the range.
33
)%
The ILG entered is out of the range.
33
)%
The entered OLG is out of the range.
48
)%
Dch position is not set to 16. When setting the time slot
pattern for a 2048 kbps interface, this value must be set to 16.
49
)%
The type of ILG or OLG entered in not an ISDN.
49
)%
The ILG or OLG entered does not exist in the system.
49
)%
When the equipment is moved, the number of the PCM
highway in the moved equipment is different from the current
equipment.
49 -
The ILG entered is not registered in the system.
FB which this error occur : FB03
49 -
The OLG entered is not registered in the system.
FB which this error occur : FB03
49
)%
When the card type is “PTU1F”, the protocol type entered
should be “Bellcore” or “Bellcore Northern Telecom”.
49
)%
When the card type is “PTU”, the protocol type entered is
“ETSI”.
49
)%
The card type is not “IPU-Q” when IP is selected.
49
)%
The card type is not “PTU” or “PTU1F” when TTC or QSIG is
selected.
49
)%
When the card type is “PTU1F”, the inputted D channel
position is not 16.
49
)%
D channel position must assign “0” when the card type is
“IPU-Q”.
49
)%
D channel position must not be assigned “0” when the card
type is notIPU-Q”.
50
)%
The T-Wait Timer can only be enabled if the Protocol is set to
National ISDN.
52
)%
The entered Channel Group conflicts with an existing ISDN
extension(s), etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The entered Channel Group number does not exist in the
system.
80
)%
An ISDN trunk cannot be assigned to the designated Shelf/
Slot/Circuit.
80
)%
The designated ILG does not exist in the system.
80
)%
The designated OLG does not exist in the system.
96
)%
The number of allowable Channel Groups has been
exceeded when a new ISDN trunk assignment is made.
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions

Table of Contents

Other manuals for Toshiba Strata CTX28

Related product manuals