System
PAD Table
4-26 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
Program 107 PAD Table Example
If the Sender is an analog telephone (PAD device number 1) and the receiver is a T1 trunk (PAD device
number 4), then the PAD value is 6. (6 = 9dB Net Loss).
PAD group numbers are assigned in Program 108 PAD Group Assignment.
Table 4-2 Program 107 PAD Table
PAD Device or Group Number of Receiver (Listener)
Analog Telephone
DKT
Analog Trunk
T1 Trunk
ISDN Station
ISDN Trunk
CONF Bridge
Music Source
Ext. Paging
IPT
PAD Group 1
PAD Group 2
PAD Group 3
..
PAD Group 123
PAD Device No. of
Sender (Speaker)
1
2
3
4
5
6
7
8
9
10
101
102
103
..
132
1 Analog Telephone 000666X
1
-0000
2 DKT 0006660 - 0000
3 Analog Trunk 006666X
1
-6000
4 T1 Trunk 6660000 - 6300
5 ISDN Station 6660000- 6300
6 ISDN Trunk 6660000- 6300
7 Conference Bridge (0) (0) (0) (0) (0) (0) (0) (0) (0) 0 0 0
8 Music Source 000000000000
9 Ext. Paging 006666000000
10 IPT -60-60 0 0-6- -60 0 0
101
2
PAD Group 1
(IP QSIG only)
3
0 0 -3 -3 -3 -3 -3 -3 -3 0 0 0
102
PAD Group 2
(ISDN PRI QSIG only)
333333333330
103 PAD Group 3
: :
132 PAD Group 32
PAD values
1. “X” data set for PAD Conference Table Assignment.
2. These are recommended channel group PAD numbers, but they can be changed in Program 302 PRI and IP QSIG.
3. For IP QSIG only. The default values for PAD Group 1 is 0dB. dB is the value for attenuation level.
To Next Page
Loading...
