Toshiba Strata CTX28 - Page 116

Station
Assignment
5-2 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
• Change DN – Enter a DN in the Primary DN field and click Change DN. Enter the new DN
assignment and click OK.
5. Setup the DN by adding values to the remaining fields.
6. Click Submit.
FIELD DESCRIPTION
01 PDN Equipment No. Enter the PDN equipment number (xxyyzz). This is the cabinet, slot, and circuit
number of the ADKU, BDKU/BDKS, PDKU, or RSTU interface PCB to which the
the PDN is, or should be assigned.
Example: If the PDN should be a assigned to a BDKU in cabinet 5, slot 2, circuit 3;
enter 050203.
CTX28 Equipment Numbers: DKT 1~8 = 0101(01~08); SLT 1 & 2 = 0104 (01~02);
DKT 9~16 = 0107 (01~08).
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
02 Station Type Select Station Type.
Possible values: DKT (default) or SLT
03 Circuit Type Select Extension or Assign Voice Mail attributes to analog circuits
Possible values: Extension (default) or Voice Mail
• Extension – Should be assigned to PDNs that are associated with Digital or
Standard telephones.
• Voice Mail – Should be assigned to PDNs associated with Voice Mail circuits.
• Announce – Not used in the U.S.A. or Canada. (This feature is available with
CTX R2.2 or higher and CTX WinAdmin R2.2G.0 and higher.)
04 COS Day1
• Day2
• Night
Assign COS to Day1, Day 2 and Night modes.
Possible values: 1~32 (default = 1)
05 DRL Day1
• Day2
• Night
DRL for DAY1, Day 2 and Night
Possible values: 1~16 (default = 1)
06 FRL Day1
• Day2
• Night
Assign FRL to Day1, Day 2 and Night modes. The higher the FRL number, the
more trunk access is available.
Possible values: 1~16 (default = 1)
07 LCR Group Station LCR Group Number
Possible values: 1~16 (default = 1)