Station
Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 5-9
Station
03 Key Strip Type Select the number of feature buttons to assign to this station.
Note Although the scroll down menu enables you to choose any value from
1~24, valid values are 10, 14 and 20.
Possible values: 1, 3, 7, 10, 14 or 20 (default)
Applies 1, 3, 10, 14, or 20 button keystrip type to digital telephones:
1 and 3 button keystrips apply to DKT2001 and DKT3001|
7 button keystrips apply to DKT3007 and SoftIPT
10 button keystrips apply to DKT2010 and DKT30010
14 button keystrips apply to the Large LCD DKT3014
20 button keystrips apply to DKT2020 and DKT3020.
04 Add on Modules Select the number of Add On Modules (ADM) assigned to this station. This field is
required if you want to program ADM FBs in Program 213. See “Key” on page 5-16.
Possible values: None (default), 1 unit, or 2 units
05 Tone First /Voice
First
Set PDN to have Tone First or Voice First signaling when called.
For each iES32 PDN, set to “Tone First”, if set to Voice First iES32 will not answer.
Possible values: Tone or Voice (default)
06 OCA Type Select the OCA type. This field must be programmed with Auto OCA Originate
below.
Possible values: Handset (default) or Speaker
09 Handsfree MIC
Setting
If you call a station configured for Voice First signalling, you can use this parameter
to enable the called parties microphone from your DKT.
Possible values: Enable (default) or Disable
10 Handsfree Tone If you call a DKT configured for Voice First signalling, you can use this parameter to
send a splash tone to the called party.
Possible values: Enable (default) or Disable
11 Ext. Ring Repeat Enable repetitive ringing for incoming CO / PBX / Centrex signals. Disabling this
parameter defaults to standard CO ringing pattern (1 sec on / 3 sec Off).
Possible values: Enable or Disable (default)
FIELD DESCRIPTION
To Next Page
Loading...
