Station
Assignment
5-12 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
23 Mail Box Selection Select the method to enter the destination Mailbox for Call Recording. If set to
“Auto” CTX uses the VM ID of the station initiating the record function.
Notes
• The DN assigned as the MSG center in PROG 200 is used to call the VM port or
Hunt group (PROG 200 FK 22).
• When set to “Auto” the VM-ID of the station initiating the record function is sent
to Stratagy ES as the destination mailbox.
• When set to “Manual Input” the user may enter any valid Mailbox followed by
the “#” sign. If the user Presses “#” without additional data the CTX will send the
VMID of the originating station.
Possible values: Auto or Manual (default)
24 MIC Init. Value Turn on the microphone automatically when making a speaker phone call.
Note The microphone must be enabled.
Possible values: On (default) or Off
25 Microphone Enable microphone.
Possible values: Enable (default) or Disable
26 Speaker Mode
Tones
Enable telephone to receive Call Waiting (Camp-on) and Ring Over Busy Tone
while on a speaker phone call.
Possible values: Yes (default) or No
27 Ring Over Busy
Cycles
Set ROB to ring two times or continuously.
Possible values: Two Cycles or Continuous (default)
Note See PRG200, 26 to enable ROB to be sent to individual telephones.
28 Attd Overflow Dest. Select overflow destination for attendant.
Possible values: Up to 32 ASCII characters (default = none)
29 Trunk Test and
Verify
Allow Trunk Tests and Verification.
Possible values: Yes or No (default)
30 Auto Line Hold Enable Automatic Line Hold. This parameter allows a station to “line hop” from one
call to another automatically by placing the first call on hold.
Possible values: Enable or Disable (default)
31 Call Progress
Dependency
Allows the telephone to be set to ring or not ring when busy on a call. If a telephone
has multiple DNs (PDN + PhDNs), set this parameter to the Line Mode.
Line Mode: Calls will ring the telephone when the user is talking on a line or DN
button if the telephone has multiple DN or line buttons in a hunt configuration. If Call
Forward Busy/No Answer is set, the telephone will Ring No Answer and then
forward when a call is delivered to the telephone while the user is talking on a DN or
CO line button.
Terminal Mode: Callers will receive busy tone when any DN or CO line button on
the telephone is in-use. If Call Forward Busy/No Answer is set on the telephone a
call to the telephone will forward immediately when a call is delivered while the user
is talking on any DN or CO line button.
Possible values: Line Mode (default) or Terminal Mode
FIELD DESCRIPTION
To Next Page
Loading...
