Trunks
300 Trunk Assignment
6-12 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
FIELD DESCRIPTION
Line No. Enter the trunk equipment number. Equipment numbers are required when
assigning a new trunk to the system. It can also be used to display the equipment
location of existing trunks.
Example: If a line should be assigned to an RCOU in cabinet shelf 5, slot 2, circuit 3,
enter 050203.
Possible values: xx = cabinet 01~07; yy =slot 01~10; zz = circuit 01~08 or Channel
01~24 (CTX670).
xx = cabinet 01; yy =slot 01~08; zz = circuit 01~24 or Channel
(CTX100)
(default = no value).
Cabinet numbers:
• CTX28 equipment assignments are fixed. See Program 100.
• CTX100 – Select 01 for Base and Expansion cabinet.
• CTX670 – Select 01 for Base and 02~07 respectively for each Expansion
cabinet.
Slot numbers:
• CTX28 equipment assignments are fixed. See Program 100.
• CTX100 – Select 01~04 for Base slots and 05~08 for Expansion slots.
• CTX670 – Select 01~08 for Base slots and 01~10 for Expansion slots.
01 Day1 Destination Type
02 Day2 Destination Type
03 Night Destination Type
Select Destination Type for each.
Possible values: : No Data (default), Dialing Digits, DISA, Built-in Modem, or Night
Bell
• No Data – no destination will ring when the line rings into the system.
• Dialing Digits – assigns the line to ring the directory number or access code
defined in the “Destination Digits” assignment
• DSIA – assigns the line to ring in as a DSIA call. DSIA dial tone will be returned
to the caller.
• Modem – assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a CTX WinAdmin PC and modem.
• Night Bell – Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open)
Day1 Destination Digits
Day2 Destination Digits
Night Destination Digits
Enter Destination, Directory Number or Access Codes for each, only if Dialing Digits
is selected as Destination Type.
• If Dialing Digits is the Destination Type, enter the Directory Number that the line
should ring.If the line should ring over external page, enter #31xx, where xx is
the external Page group number.
• If the default page access code #31 was changed, use the new page access
code as the leading digits.
• Line access codes and network routing numbers can also be entered to route
incoming calls back out to a public or private network number.
Possible values: Up to 32 digits (default = no value)
04 MOH Source Select the MOH source for Analog DIT Trunk. The Scroll key must be used to select
MOH sources indicated by 10 or higher.
Possible values: External1~15 (default = External1)
To Next Page
Loading...
