Trunks
309 Direct Inward Dialing
6-14 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
04 Pool Key Group If this line group is not assigned to ring a CO, GCO or a Pooled line key, enter the
Destination type that should ring:
No Data - no destination will ring when the line rings into the system.
Dialing Digits - assigns the line to ring the directory number or access code defined in
the ’Destination Digits’ assignment.
DISA - assigns the line to ring in as a DISA call - DISA dial tone will be returned to the
caller.
Modem - assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a WinAdmin PC and modem.
Night Bell - Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open)..
Possible values: 0~32 (CTX28 & CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670
Exp),
(default = 0)
05 Audio Day1 Dst Type
06 Audio Day2 Dst Type
07 Audio Night Dst Type
If this line group is not assigned to ring a CO, GCO or a Pooled line key, enter the
Destination type that should ring:
No Data - no destination will ring when the line rings into the system.
Dialing Digits - assigns the line to ring the directory number or access code defined in
the ’Destination Digits’ assignment.
DISA - assigns the line to ring in as a DISA call - DISA dial tone will be returned to the
caller.
Modem - assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a WinAdmin PC and modem.
Night Bell - Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open).
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night Bell
Audio Day1 Destination
Audio Day2 Destination
Audio Night Destination
Enter the Destination Directory Number or Access Code.
Possible values: Up to 32 digits (default = no value)
If Dialing Digits is the Destination Type enter the Directory Number that the line should
ring. If the line should ring over external page, enter #31xx, where xx is the external
Page group number. If the default page access code #31 was changed, use the new
page access code as the leading digits.
Line access codes and network routing numbers can also be entered to route incoming
calls back out to a public or private network number.
08 Data Day1 Dst Type
09 Data Day2 Dst Type
10 Data Night Dst Type
Select the Destination Type for data calls
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night Bell
Data Day1 Destination
Data Day2 Destination
Data Night Destination
Enter the Destination Directory Number or Access Code.
Possible values: Up to 32 digits (default = no value)
If Dialing Digits is the Destination Type enter the Directory Number that the line should
ring. If the line should ring over external page, enter #31xx, where xx is the external
Page group number. If the default page access code #31 was changed, use the new
page access code as the leading digits.
Line access codes and network routing numbers can also be entered to route incoming
calls back out to a public or private network number.
FIELD DESCRIPTION
To Next Page
Loading...
