Trunks
318 DID Intercept Assignments
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 6-17
Trunks
05 Audio Day1 Dst Type
06 Audio Day2 Dst Type
07 Audio Night Dst Type
Select the Audio/Speech call Day1 destination type.
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night
Bell
• No Data – no destination will ring when the line rings into the system.
• Dialing Digits – assigns the line to ring the directory number or access code
defined in the “Destination Digits” assignment
• DSIA – assigns the line to ring in as a DSIA call. DSIA dial tone will be returned
to the caller.
• Modem – assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a CTX WinAdmin PC and modem.
• Night Bell – Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open)
Audio Day1 Dst. DN
Audio Day2 Dst DN
Audio Night Dst DN
Enter the Destination Directory Number. Destination DN is only required if the
destination type is “Dialing Digits”
Possible values: Up to 32 ASCII characters (default = no value)
08 Data Day1 Dst Type
09 Data Day2 Dst Type
10 Data Night Dst Type
Select the data call Day1 destination type
Possible values: No Data (default), Dialing Digits, DISA, Built-in Modem or Night
Bell
• No Data – no destination will ring when the line rings into the system.
• Dialing Digits – assigns the line to ring the directory number or access code
defined in the “Destination Digits” assignment
• DSIA – assigns the line to ring in as a DSIA call. DSIA dial tone will be returned
to the caller.
• Modem – assigns the line to ring the remote maintenance modem on the CTX
processor. Used to call into the system with a CTX WinAdmin PC and modem.
• Night Bell – Assigns the line to cause the night relay to pulse (one-sec.close/3-
sec.open)
Data Day1 Dst DN
Data Day2 Dst DN
Data Night Dst DN
Enter the Destination Directory Number. Destination DN is only required if the
destination type is “Dialing Digits”
Possible values: Up to 32 ASCII characters (default = no value)
11 DID/DNIS No. VMID Enter the VM mail box number which should answer calls for this DID/DNIS number.
Possible values: Up to 10 digits (default = no value).
Note This code is only sent if using SMDI VM integration in Program 580, 01.
This code will be replaced, after voice mail answers, by the DTMF code set
in Program 318, 15 DID/DNIS DTMF VMID code - if programmed;
therefore, if using Program 318, 15 code, this VMID code is not necessary.
This mail box number will be sent to voice mail on a DID/DNIS call that rings directly
to voice mail; and, on a direct DID/DNIS call to a DN that forwards to voice mail
before it is answered by the DN.
If a DID/DNIS call is answered by a station and then transferred to a DN that
forwards to voice mail, this mail box number of the DID/DNIS number, or the
forwarding DN's mail box number will be sent to voice mail per Program 579, 01.
If this VMID code is not set, direct DID/DNIS calls will go to the VM general greeting
and DID/DNIS calls that forward from a DN to VM will go to the DN's VMID mail box.
This Voice Mail box number is added to SMDI packets of direct and forwarded
DID\DNIS calls to voice mail as explained above.
FIELD DESCRIPTION
To Next Page
Loading...
