Telephone Button Programming
200 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-37
Telephone Button
Programming
204-27 Ring Over Busy
Cycles
)%
, n,
+ROG
n = 1. Two Cycles
2. Continuous
Set ROB to ring two times or continuously.
Note See PRG200, 26 to enable ROB to be sent to individual
telephones.
204-28 Attd Overflow Dest.
)%
, n,
+ROG
n = Up to 32 digits Select overflow destination for attendant.
204-29 Trunk Test and Verify
)%
, n,
+ROG
n = 1. Yes
2. No
Allow Trunk Tests and Verification.
204-30 Auto Line Hold
)%
, n,
+ROG
n = 1. Enable
2. Disable
Enable Automatic Line Hold. This parameter allows a station to “line
hop” from one call to another automatically by placing the first call on
hold.
204-31 Call Progress
Dependency
)%
, n,
+ROG
,
+ROG
n = 1. Terminal Mode
2. Line Mode (default)
Allows the telephone to be set to ring or not ring when busy on a call.
If a telephone has multiple DNs (PDN + PhDNs), set this parameter to
the Line Mode.
Terminal Mode: Callers will receive busy tone when any DN or CO
line button on the telephone is in-use. If Call Forward Busy/No
Answer is set on the telephone a call to the telephone will forward
immediately when a call is delivered while the user is talking on any
DN or CO line button.
Line Mode: Calls will ring the telephone when the user is talking on a
line or DN button if the telephone has multiple DN or line buttons in a
hunt configuration. If Call Forward Busy/No Answer is set, the
telephone will Ring No Answer and then forward when a call is
delivered to the telephone while the user is talking on a DN or CO line
button.
Table 13-16 Programs 203~204 (continued)
Button Sequence Value(s) Summary
To Next Page
Loading...
