Telephone Button Programming
200 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-43
Telephone Button
Programming
Door Lock Cancel
Flash - Short
Flash - Long
• Attendant
• Supervised
Microphone Cut Off (MCO)
Message Waiting
• Phantom (PhDN) Message Waiting
Night Transfer
Paging
One Touch Button
• Page All Groups
• Page Individual Groups
• Emergency Page - Individual Group
• Emergency Page - All Groups
• Answer Feature
Position Busy
Programming Mode (Enter User Programming Mode)
Split (Conference Split)
Speed Dial (register Speed Dial)
Start Application
Trunk Test
Voice Mail
• Auto Voice Mail Playback
• Auto Voice Mail Record
• Call Monitor
Notes
1. T = Telephone type PCB
2. L = CO line type PCB
3.
= Allowed T1/PRI slots
4. The Base cabinet allows Speaker OCA and DIU data with PDKU in all slots; expansion
cabinets provide these features in slots S_01~S_06 only.
5. Last available slot: B1C=S108, B2C=206, B3C=310, and B5C=510.
Table 13-23 Programs 206
Button Sequence Value(s) Summary
206
Phantom DN
,
+ROG
This command assigns PhantomDN parameters.
206-00 Phantom DN
n,
+ROG
n = Up to 5 digits Enter Phantom DN.
206-01 Owned PDN
)%
, n,
+ROG
n = Up to 5 digits Set PhantomDN’s Owner Station
206-02 Tone/Voice First
)%
, n,
+ROG
n = 1. Tone First (default)
2. Voice First
Select from Tone first, or Voice first signaling.
Table 13-22 Flexible Button Assignment Feature Code Table (continued)
Feature Buttons Code
To Next Page
Loading...
