Telephone Button Programming
300 Series Programs
13-68 Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Table 13-31 Programs 318~320
Button Sequence Value(s) Summary
318
DID Intercept
Assignment
,
+ROG
This command assigns the DID Routing table when DID numbers are
undefined or not received.
318-00 ILG Number
n,
+ROG
n = 1~32 (CTX100)
1~50 (CTX670 Basic)
1~128 (CTX670 Exp.)
Enter ILG number.
318-01 Type
)%
, n,
+ROG
n = 1. No DID
2. Not Determined
Select Routing Type.
318-02 MOH Source
)%
, n,
+ROG
n = 1. Quiet Tone
2. External 1 (default)
3. External 2
4. External 3
5. External 4
6. External 5
7. External 6
8. External 7
9. External 8
10. External 9
11. External 10
12. External 11
13. External 12
14. External 13
15. External 14
16. External 15
Select Music On Hold
318-03 GCO Destination
)%
, n,
+ROG
0~32 (CTX100)
0~50 (CTX670 Basic)
0~128 (CTX670 Exp.)
(default = 0)
GCO Key Group number.
318-04 Pooled Line Group
)%
, n,
+ROG
0~32 (CTX100)
0~50 (CTX670 Basic)
0~128 (CTX670 Exp.)
(default = 0)
POOL Line Key Group Number.
318-
05~07
Audio Day1/Day2/
Night Dst Type
)%
~
)%
, n,
6SNU
n = 1. No Data (default)
2. Dialing Digits
3. DISA
4. Built-in modem
5. Night Bell
Select the Audio/Speech call Day1 destination type.
•
No Data – no destination will ring when the line rings into the
system.
• Dialing Digits – assigns the line to ring the directory number or
access code defined in the “Destination Digits” assignment
• DISA – assigns the line to ring in as a DISA call. DISA dial tone
will be returned to the caller.
• Modem – assigns the line to ring the remote maintenance modem
on the CTX processor. Used to call into the system with a CTX
WinAdmin PC and modem.
• Night Bell – Assigns the line to cause the night relay to pulse
(one-sec.close/3-sec.open)
Audio Day1/Day2/
Night Dst DN
n1,
+ROG
n1 = Up to 32 digits Enter the Destination Directory Number. Destination DN is only
required if the destination type is “Dialing Digits”
To Next Page
Loading...
