Toshiba Strata CTX28 - Page 417

Telephone Button Programming
600 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-93
Telephone Button
Programming
657
Network COS
Mapping Table
Assignment
 , +ROG
This table translates a Network COS received as part of a Traveling
Class Mark to a local Class of Service for access to local services.
There is no translation of Outgoing Network COS.
Network COS
n,
+ROG
n = 1~32 Enter the Network COS to be translated (1~32).
657-01 Local COS
)% , n, +ROG
n = 1~32 Enter the Local COS to be used in place of the received Network
COS (1~32).
657-02 Off-hook Call
Announce
)% , n, +ROG
n = 1. Enable
2. Disable (default)
Choose whether an incoming call with this Network COS can activate
Off-Hook Call Announce.
657-03 System Speed Dial
)% , n, +ROG
Choose whether an incoming call with this Network COS can use a
System Speed Dial number to make an otherwise restricted outgoing
call.
657-04 COS Override
)% , n, +ROG
Choose whether an incoming call with this Network COS can use
Class of Service Override.
657-05 TGAC Override
)% , n, +ROG , +ROG
Choose whether an incoming call with this Network COS can override
local Trunk Group Access Control. Typically an attendant function.
658/
659/
660
Network DRL
Mapping Tables
 , +ROG
This command is used to establish two mapping tables to equate
local DRLs with network DRLs for both outbound and inbound
network calls.
Type
n,
+ROG
n = 1. Outbound
2. Inbound
Choose “Outbound” to equate the DRL of the local originator to a
Network DRL. Choose “Inbound” to equate a received Network DRL
with a local DRL for local termination.
Network DRL/FRL/
QPL
)% , n, +ROG
n = 1~16 Enter the local DRL/FRL/QPL you want to map to Network DRL/FRL/
QPL 1~DRL/FRL/QPL 16. This value can be different depending on
the type of table chosen above.
661
Network DN Table
 , +ROG
This program assigns the PDN, PhDN or Pilot DNs to a CTX node ID.
This include all DNs in all CTX nodes on the CTX network, except the
DNs in the node you are currently programming.
661-00 Network DN
n,
+ROG
n = Five ASCII characters max.
(Default = No Data)
Enter the PDN, PhDN or Pilot DNs that should be assigned to a CTX
Node ID. This include all DNs in all CTX Nodes on the CTX network,
except the DNs in the node you are currently programming.
661-01 Node ID
)% , n, +ROG
n = Six ASCII characters max.
(Default = No Data)
Enter the CTX Node ID that should be assigned to the DN.
673
Delete Node ID for
Private Networking
Over IP
 , +ROG
This program deletes Node IDs..
673-00 Node ID
n,
+ROG
n = upto six digits Delete Node ID
673-01 Registration State
)% , n, +ROG
n = 1. doesn’t exist
2. exist
3. delete
Delete Registration State.
Table 13-38 Programs 650~660 (continued)
Button Sequence Value(s) Summary