Applications, Tips and Tricks
Strata CTX BRI Video Conferencing Programming
Strata CTX Programming - Part 4: Appendices 6/04 A-5
Applications, Tips and
Tricks
Strata CTX BRI Video Conferencing Programming
The table below shows the programs required to program a PRI line to ring to a RBSU interface to allow
for Video Conferencing capabilities.
The following may differ in your system: card slot assignments, trunk groups, channel groups and BRI
station numbers.
The following program changes are required once the system has been installed and initialized.
Programs Description
Program 100 Card Assignment
105=RPTU and 107=RBSU S/T Interface with each two TIE’s
Program 105 System Data
Primary Clock, FB21=RPTU card slot, 10501
Program 304 Incoming Line Groups
ILG=1, FB1=ISDN, FB2=CO, FB3=DID, FB4=Standard
Program 306 Outgoing Line Groups
OLG=1, FB1=ISDN, FB2=CO/DID, FB3=Standard
Program 309 Direct Inward Dialing
ILG=1, FB1=3000, FB5 through FB10=Dialing Digits with Destination Digits 3000
Program 302 PRI Trunks
Channel Group=1, FB1=010501, FB2=Nat’l ISDN, FB3=1, FB4=1, FB7=24,
FB 8=Enable, FB9=Enable, FB11=Enable, FB12=Enable, FB19=Enable
Program 320 “B” Channels
FB00=010501, FB1 through FB23=Enable
Program 202 ISDN BRI Station
Prime DN=3000, FB1=010701, FB2=2, FB3=Nat’l ISDN, FB4=Point to Multi-Point,
FB13=Enable, FB14=Enable
Prime DN=3001, FB1=010702, FB2=3, FB3=Nat’l ISDN, FB4=Point to Multi-Point,
FB13=Enable, FB14=Enable
Prime DN=3002, FB1=010703, FB2=4, FB3=Nat’l ISDN, FB4=Point to Multi-Point,
FB13=Enable, FB14=Enable
Prime DN=3003, FB1=010704, FB2=5, FB3=Nat’l ISDN, FB4=Point to Multi-Point,
FB13=Enable, FB14=Enable
Note FB2 must be a different channel group for each BRI station and cannot
conflict with PRI channel group.
To Next Page
Loading...
