System Error Codes
Service Programming Error Codes
B-22 Strata CTX Programming - Part 4: Appendices 6/04
507
33
)%
The DDCB Equipment number entered is invalid.
33
)%a)%
The destination number value is out of range (when
destination type is Paging Group).
33
)%a)%
The allowable number of Paging Groups have been
exceeded.
33
)%
The entered Ring Duration is invalid.
49
)%
Door Phone number entered conflicts with an existing Door
Phone number.
49
)%
The equipment assigned in DDCB Equipment Number is
already in use.
49
)%
The entered value conflicts with an existing DKT extension.
50
)%a)%
The destination number is not registered.
52
)%
The entered Circuit conflicts with an existing door lock.
80
)%
The entered Door Phone number does not exist in the
system.
80
)%
The PCB Type designated for this circuit must be a DKU.
82
)%
The entered Door Phone number does not exist in the
system.
96
)%
The allowable number of Door Phones has been exceeded.
508
33
)%
The entered equipment value is invalid.
49
)%
The designated BIOU PCB circuit is used by another device
(Night Bell, etc.), or two or more door locks are designated for
the same BIOU PCB.
49
)%
The PCB Type designated for this DDCB circuit must be a
PDKU or BDKU.
49
)%
The DDCB Equipment number entered conflicts with an
existing door lock.
52
)%
Other devices (DKT extensions, door phones, etc.) are
designated for the specified DDCB circuit.
96
)%
The allowable number of Door Locks has been exceeded.
509 -
No error occurs for this command except for common errors.
510 49
)%
The specified COS Override Code digit is invalid.
512 -
No error occurs for this Program except for common errors.
513
33
)%
The ILG entered is out of the range.
80
)%
ILG number enter does not exist.
514
33
)%
The OLG entered is out of the range.
80
)%
The entered OLG number does not exist.
515 -
No error occurs for this Program except for common errors.
Program Code Occurred FB
Sub-
parameter
Error Descriptions
To Next Page
Loading...
