Toshiba Strata CTX28 - Page 487

System Error Codes
Service Programming Error Codes
Strata CTX Programming - Part 4: Appendices 6/04 B-25
System Error Codes
540
48
)%
An incoming destination number must be entered when After
Shift Type field is set to Dialing Digits.
51
)% The entered value conflicts with an existing number scheme.
52
)%
The entered DN conflicts with an existing DKT, ISDN
extension, etc.
80
)% The entered DN does not exist.
541
20
)%
A character(s) that is not permitted is included in the specified
code.
52

The entered DN conflicts with an existing DKT, ISDN
extension, etc.
80
 The entered DN does not exist.
550
33
)%a)% The OLG entered is out of the range.
49
)%a)%
Two or more OLG numbers with the same value exist in the
same group.
80
)%a)%
The entered OLG number does not exist.
551 32
)%a)%
The value entered is not permitted.
570
49
)%
Registered Digit Length cannot be less than the Verified Digit
Length.
50
)%
Registered Digit Length cannot be less than the Verified Digit
Length.
571
49
)%a)%
The same account code cannot be repeated.
50
)%a)%
The same account code cannot be repeated.
573
33
)%a)%
The door phone number entered is out of the range.
80
)% The entered Door Phone does not exist.
576
33
)% The tenant number entered is not “1”.
33
)% The paging group number entered is out of the range.
80
)% The entered Paging Group does not exist.
577
33
)% The entered circuit type is out of range.
33
)% The Ckt Type number entered, CO, GCO or POOL is invalid.
51
)% The entered circuit number is invalid.
52
)% The entered circuit number is invalid.
80
)%
The Device installed in the Circuit does not existed in the
system.
80
)% The entered station number does not exist.
579 -
 No error occurs for this Program except for common errors.
580
52
 The entered DN is not a VM extension.
80
 No error occurs for this command except for common errors.
Program Code Occurred FB
Sub-
parameter
Error Descriptions