D292144.9.fm System Alarm Messages
Chapter 6: Troubleshooting 6-7
Carrier Motion System Alarm
If the Taper’s Carrier Motion Sensor detects that carrier tape is
not moving through the track, it will trigger a Carrier Motion
Tape system alarm.
When the Carrier Tape Motion system alarm is activated, tape advance stops, a beep sounds
and a warning appears on the HMI.
If the carrier tape is jammed, clear the jam and ensure that the carrier tape is loaded correctly
and feeding into the Taper correctly. Check the sprocket holes in the tape to ensure they are not
malformed, replace if necessary. Press CONTINUE to clear the error message, then press Start
to continue operation.
To Next Page
