6-10 TM-500 User’s Guide
System Alarm Messages D292144.9.fm
Heat Seal Temperature Out of Range System Alarm
The Heat Seal Temperature Controls are located on the front of the Taper.
When Heat Seal is enabled and the Heat Shoe temperatures are either too
hot or too cold, a Heat Seal Temperature Out of Range system alarm will
activate.
When this occurs, tape advance stops, a beep sounds and a warning appears on the HMI.
To clear the Heat Seal Temperature Out of Range System Alarm, wait for the heat shoes to
reach their set point and then press CONTINUE to clear the alarm and resume operation.
To Next Page
