D292144.9.fm System Alarm Messages
Chapter 6: Troubleshooting 6-11
Low Cover Tape System Alarm
The Low Cover Tape sensor is located on the Cover Tape Arm. It
detects when the cover tape supply on the Cover Tape Reel is
below a preset minimum.
If an operator attempts to start a job when the cover tape level is below the sensor, operation will
not begin. Instead a beep will sound and a Low Cover Warning message will appear on the HMI.
The operator can either resolve the warning by loading a full reel of cover tape or ignore the
warning and push START again to continue with the current level of cover tape.
To Next Page
