Valleylab CUSA EXcel-8 - Lubricate the Handpiece Connector O-Rings; Recalibrate the Handpiece; Replace the Handpiece Connector O-Rings

Maintain the Handpiece
Figure 9-2.
Replacing the handpiece connector
o-rings
Lubricate the Handpiece Connector O-Rings
Keeping the o-rings lubricated prevents them from drying out and
cracking, which may cause handpiece cooling problems.
Items needed: A high viscosity lubricant such as silicone grease.
Items to be lubricated: The four o-rings on the handpiece connector water
prongs.
Replace the Handpiece Connector O-Rings
Regularly replacing the o-rings prevents excessive wear, which may result
in handpiece cooling problems.
Items needed: O-Ring maintenance kit (Part Number 260-650-000), which
includes o-rings, an insertion tool, and instructions.
Items to be replaced: The four o-rings on the handpiece connector water
prongs.
Refer to Figure 9-2.
Tn
la P
Handpiece Connector insertion tool
water prongs .
O-ring
Recalibrate the Handpiece
Handpieces for the CUSA EXcel system do not need recalibration unless a
problem develops. If this happens, contact Valleylab to arrange returning
the handpiece for service. (Refer to Return Equipment for Service in
Section 13, Repair Policy.)
CUSA
EXcel-8
System
Service
Manual
9-5
山
9lsAS
189X3
YSNI
au}
BUIUIEIUIEIN