Valleylab CUSA EXcel-8 - List of Figures

List of Figures
Figure 2-1. The pre-aspiration holes and threads on tips 2-3
Figure 2-2. The three handpieces in the CUSA EXcel system 2-5
Figure 3-1. Replacing fuses 3-10
Figure 3-2. Disconnecting control panel assembly cables 3-11
Figure 3-3. Removing the control panel overlay 3-12
Figure 3-4. _ Installing the control panel overlay 3-14
Figure 3-5. Installing the reference cards 3-15
Figure 4-1. Console structural features 4-2
Figure 4-2. Control panel features 4-4
Figure 4-3. Control panel features (continued) 4-6
Figure 4-4. Console body—front view 4-8
Figure 4-5. Console body—view of the right side 4-10
Figure 4-6. Console—rear view 4-12
Figure 4-7. Console—rear view (continued) 4-14
Figure 4-8. Control panel symbols 4-16
Figure 6-1. The handpiece components 6-2
Figure 6-2. Reserve power vs. TISSUE Select settings 6-7
Figure 6-3. Reserve power vs. amplitude setting 6-9
Figure 7-1. The display organization on the control panel 7-3
Figure 9-1. Cleaning the handpiece with a soft cloth 9-4
Figure 9-2. Replacing the handpiece connector o-rings 9-5
Figure 11-1. Right and left sides of the console 11-3
Figure 11-2. The wiring harness on the dual 24 volt power supply 11-7
Figure 11-3. Cables on the ultrasonics PCB assembly 11-9
Figure 11-4. The ultrasonics PCB fan assembly connections 11-10
Figure 11-5. Plugging the adapter for the syphon valve cable assembly into the
connector at J6 on the ultrasonics PBC 11-11
Figure 11-6. Disconnecting control panel assembly cables 11-13
Figure 11-7. Removing the Machine Control PCB from the control panel assembly
11-14
Figure 11-8. The layers of control head components 11-16
Figure 11-9. Disconnecting control panel cables 11-17
Figure 11-10. Disconnecting the 50-pin ribbon cable and removing the Machine
Control PCB 11-19
Figure 11-11. Removing the Display PCB from the control head assembly 11-19
Figure 11-12. Removing the ends from the suction pump chamber 11-23
|
CUSA
EXcel-8
System
Service
Manual
xiii