Valleylab CUSA EXcel-8 - Page 14

Figure 11-13.
Figure 11-14.
Figure 11-15.
Figure 11-16.
Figure 11-17.
Figure 11-18.
Figure 11-19.
Figure 11-20.
Figure 11-21.
Figure 11-22.
Figure 11-23.
Figure 11-24.
Figure 11-25.
Figure 11-26.
Figure 11-27.
Figure 11-28.
Figure 11-29.
Figure 11-30.
Figure 11-31.
Figure 11-32.
Figure 11-33.
Figure 11-34.
Figure 11-35.
Removing
the
suction
pump
enclosure
from
the
console
11-23
Disconnecting the suction tube at the contamination guard 90°
elbow 11-24
Disconnecting the suction tube from the left end of the suction
control valve 11-24
Pulling the strain relief bushing away from the manifold bracket 11-25
Removing the manifold bracket from the console 11-25
Removing the suction control valve from the manifold bracket 11-26
Removing the suction hose and clamp from the suction control valve
11-27
Removing the suction tube and clamp from the “T” fitting 11-30
Pulling the split bushing away from the manifold bracket 11-30
Disconnecting cables from the suction pump to the suction pump
controller card 11-31
Removing the suction tube and strain relief bushing from the suction
pump and its wires 11-33
Removing the suction pump from its bracket mount 11-33
Attaching the suction pump motor to its mounting bracket, making
sure to center the pump on the bracket 11-34
Removing the cable clamps and screws from the suction pump
controller card 11-36
rs
tema
e
Removing the irrigation pump bezel 11-39
Removing the suction pinch valve 11-39
Removing the irrigation pump bezel 11-41
Removing the irrigation pump head 11-42
Disconnecting the irrigation pump gear motor from the control card
11-43
Replacing the gear motor/pump head coupler on the motor drive
shaft 11-44
Replacing the handpiece flow sensor 11-47
Removing the end bell and tubing from the cooling water pump head
11-50
O-rings on cooling water reservoir connectors 11-51
CUSA EXcel-8 System Service Manu