Valleylab CUSA EXcel-8 - Calibration; For Your Information

Calibration
In this section:
* Tools/equipment needed for calibrations
* DC bias power supply
e Suction pump
* Motor for the cooling water pump.
For Your Information
In the CUSA EXcel system, several components may require calibration.
This section describes how to do the calibrations.
In most cases, you need to calibrate a component only when you replace
it. These procedures stand alone; that is, you can use one without
reference to others.
High Current Hazard Do not touch the ultrasonics PCB heat sink while the
CUSA EXcel system is energized. The heat sink is isolated from ground, and can
deliver very high current, resulting in injury.
CUSA EXcel-8 System Service Manual 12-1