Inputs and Outputs Diagnostics Section
©Vertical Express 3-28 Printed in USA April 2020
This manual shows only the parameters that have an operational relevance to the ICON32. The UIT may have
additional parameters available, which should not effect the controller operation.
PID1-PID64 Position Indicator - Digital Disc - Car or Controller for Car and Hoistway
PIEx Position Indicator - Per floor cascading discrete PI. Active during Auto and Fire Service.
PIFx Position Indicator - Per floor cascading discrete PI. Active during Auto—Disabled during Fire Service.
PIH1-PIH64 Position Indicator - Main Landing Hoistway
PHLBUZ Phone Line Buzzer
PHLFLT Phone Line Fault
PHLI Phone Line Indicator
PHLRST Phone Line Reset
RCS
Remote Car Station Activation - Input - Door operation field programmable via I/O. Requires setting
D32=0. All inactive I/O will default to D32=0.
RCSD1
Remote Car Station Door 1 - The doors do not automatically open upon arrival at a car call. Doors open
fully with DOB/DOBR, and will not close until DCB/DCBR is activated.
RCSD2
Remote Car Station Door 2 - The doors automatically open upon arrival at a car call, and after a delay,
will close back (similar to door operation on normal automatic operation).
RCSD3
Remote Car Station Door 3 - The doors do not automatically open upon arrival at a car call. The doors
open fully with DOB/DOBR, but will close when DOB/DOBR is released.
RCSD4
Remote Car Station Door 4 - The doors do not automatically open upon arrival at car call.
• The doors will open with constant pressure on DOB/DOBR, but will close if DOB/DOBR is not main-
tained until the doors are opened fully.
• The doors will not close until DCB/DCBR is activated, but will reopen if DCB/DCBR is not maintained
until the doors are closed fully.
RCSI Remote Car Station Active Indicator
RUNDLY Delay Motor Start Sequence - Input
SABO Sabbath Control
SABOI Sabbath Control Indicator
SAFC Safety Circuit Control - 186
SAFECAR Safe Car Switch Monitor
SAFEI Safeties Indicator
SAFGR Safety Gear Switch Monitor
SAFHW Safe Hoistway Switches Monitor
SAFMR Safe Machine Room Switches Monitor
SAFPLD Safe PLD Monitor
SAFRB Safe Runbug Stop Switch Monitor
SAFSP Safe Safety Processor Monitor
SE Safety Edge - Front
SEIS Seismic Operation
SEISI Seismic Operation Indicator
SEISR Seismic/Counterweight Derail Operation Reset
SER Safety Edge - Rear
SOA Security Operation Activation
SOABP Car Logic Not On Program B (A/B Switch Inactive) and Group not on Program B
SOLOA Security Override Lockouts
SOO Security Operation Override
SOTL Security Operation Total Lockout
SOTLI Security Operation Total Lockout Indicator
SOTOA Security Operation Total Override Active
SSL1-SSL128
Smoke Sensor Landing (Input) - During the time that Code Blue is overriding PH1 Fire Service, an active
SSL input inhibits the car calls at the corresponding landing.
STBC Shunt Trip Breaker Control
Designator (cont.)
Name
To Next Page
Loading...