Vertiv Liebert AC8 - Page 146

SETUP OUTPUTS
Setup output of device
Select output to edit
OUTPUTDEFINITION
*******************************************
NO=NORMALLY OPENED
1=DEVICE_1NO-OP-E-ENC=NORMALLY CLOSED
2=DEVICE_2NO-OP-E-E
3=DEVICE_3NO-OP-E-EOP=OPERATING/ON
4=DEVICE_4NO-ST-E-EST=STANDBY MODE
5=DEVICE_5NO-NU-E-ENU=NOT USED
6=DEVICE_6NO-NU-E-E
7=DEVICE_7NO-NU-E-ED=DISABLE DEVICE ON ALARM CONDITION
8=DEVICE_8NO-NU-E-EE=LEAVE DEVICE OPERATING ON ALARM CONDITION
9=RETURN TO SETUP MENU
0=RETURN TO MAIN MENUD=DISABLE DEVICE IN EMERGENCY POWER OP
E=LEAVE DEVICE OPERATING (EMERGENCY POWER OP)
*******************************************
SELECT A NUMBER:1
>SET TO NORMALLY OPENED(NO) OR NORMALLY CLOSED(NC)
>[NO]
>[]
>DEVICE_1 TO OPERATING/ON(OP), STANDBY MODE(ST), NOT USED(NU)
>[OP]
>[]
>DEVICE_1 TO ENABLE(E) OR DISABLE(D) DEVICE ON ALARM
>[E]
>[]
>DEVICE_1 TO ENABLE(E) OR DISABLE(D) DEVICE IN EMERGENCY POWER OP
>[E]
>[
Setup Modem & Pagers
For details on this topic, see Setup System - Setup Modem & Pagers on page72.
Pager Setup
For details on this feature, see Pager Setup - Pager Number and PIN on page78 and Pager Setup -
Communications Check (Service Terminal Interface only) on page80.
Setup Modem & Pagers - Pager Setup
Vertiv | Liebert® AC8 User Manual | 140