Vertiv Liebert AC8 - Backing up the Event Log (Service Terminal Interface Only)

SOURCE Digital Input Analog Input Digital Output
CONDITIONS
RECORDED
EVENT
NORMAL
HIGH SETPOINT EVENT
LOW SETPOINT EVENT
RETURN TO NORMAL
SENSOR PROBLEM
(denoted by dashes ------)
FORCE ON
FORCE OFF
AUTO
HW FORCE ON
ON
OFF
DISABLED
STAGING DEVICE ON
STAGING DEVICE OFF
RESTORED
STARTED
SOURCE Panel
CONDITIONS
RECORDED
ALARMS CLEARED
ALARM SILENCED
DIAL OUT TEST PASSED
DIAL OUT TEST FAILED
UNSUCCESSFUL PAGE
DEFAULT PASSWORD SET
MODEM RESET
TIME & DATE SET
USER LOGIN
NOT USED DEVICES IN ZONE
NO STANDBY OUTPUTS AVAILABLE
NO STANDBY TESTING DEVICE
AVAILABLE
EMERGENCY PWR ALARM
STAGING DISABLED
Table 5.2
Event log conditions
If there are no records in the log, the screen displays the message:
NO EVENTS
Viewing Additional Screens
There may be up to 99 records of event data.
• To view additional records, use the arrows¯.
• To return to the previous screen, press the ESC key.
5.3.2 Backing Up the Event Log (Service Terminal Interface only)
The event log is stored as a file in the Liebert AC8; it can hold no more than 99 records. When the log is
full, the oldest records are deleted from the end of the file as new event records are added at the
beginning.
You may back up the event log file to a remote computer using the Service Terminal Interface, as
described in Back Up Log Files (Service Terminal Interface only) on page50.
To delete all records in the event log, see Clear Alarms & Logs on page105.
Vertiv | Liebert® AC8 User Manual | 40