6 SILENCE ALARM & BACKUP LOG FILES (SERVICE
TERMINAL INTERFACE)
This section describes two features that are available in the Service Terminal Interface:
• Silence Alarm
• Backup Log Files
6.1 Silence Alarm
(Service Terminal Interface)
The Silence Alarm menu item allows you to silence the audible alarm and reset the Common Alarm Relay
output if the common alarm is configured to reset with silence.
This menu item is available only through the Service Terminal Interface and Liebert SiteScan Web™
connection.
NOTE: An alarm may also be silenced by pressing any key on the LCD keypad on the front of the
Liebert AC8. The LCD does not offer Silence Alarm as a menu item.
To silence the alarm remotely through the Service Terminal Interface:
• Connect to the Liebert AC8 either from a remote computer or through the RS232 port (see
Connecting to the Service Terminal Interface on page111).
• At the Main Menu, enter 8 (Silence Alarm).
• At the Silence Alarm menu, shown below, enter 1 to silence the audible alarm immediately. (To
exit without silencing the alarm, enter 2 or press the Escape key.)
Silence Alarm
SILENCE ALARM
Silence alarm and reset
common alarm relay if
common alarm relay is
configured to reset with
silence alarm
1=SILENCE ALARM
2=RETURN TO MAIN MENU
SELECT A NUMBER:1
>ALARM HAS BEEN SILENCED
• A confirmation message appears: “Alarm has been silenced.”
NOTE: Through Liebert SiteScan Web, this option is available via the Liebert AC8 Graphic Screen.
Vertiv | Liebert® AC8 User Manual | 49
To Next Page
Loading...